Carolyn’s Tote Bag
Another friend asked if I would make her a tote bag and here is the result. Carolyn’s Tote is made from the much-loved scraps of an upholstery project. The fabric is a cotton/rayon blend with a small woven floral repeat. The darker contrast and lining is a cotton twill. Carolyn provided me with a reusable shopping bag which she likes the size of, and I created a pattern based on the dimensions of that bag. The bag measures 12 inches wide by 13 inches tall by 8 inches deep. I decided on a contrast bottom to add some interest but also to aid in hiding dirt. The two outer pockets with curved edge are designed to hold a water bottle or umbrella. Piping neatly finishes the top edge of the pocket and the entire bag.
When constructing the bag I first had to decide how to apply the contrast bands along the bottom edge. I realized that stitching the bands as separate pieces would allow me to apply them on the pockets, thus allowing the pockets to run the full depth of the bag. The challenge then became to match the four corners of the contrast bands for a professional finish. I found that basting an inch or two above and below this crucial intersection and checking the match before stitching the entire seam assured a perfect match.
The lining contains two pockets, both on the larger sides of the bag. One runs the full width and depth of the side. I found this needed a snap at the center top to keep the pocket from gaping open. The other pocket runs the entire width of the bag but is only about 6 inches deep. It is sewn into three separate compartments and designed to hold phone, sunglasses, etc.